Optotrak

Optotrack Certus
	Optotrack Certus
Manuals
	See also: § Manuals

Usage

Startup

Turn on power rails.
Turn on computers and log in.
Turn on ODAU unit (when used) and wait for it to beep. If the ODAU unit is not used, don’t turn it on.
Turn on Sensor Unit 1 and wait for it to beep. Remove caps.
Turn on Sensor Unit 2 (when used) and wait for it to beep. Remove caps. If sensor unit 2 is not used, don’t turn it on.
Turn on Control Unit and wait for it to beep.
Start First Principles and load your First Principles experiment. The used units will beep.
When not all used units are found, make sure that the units you use are turned on, and that all other units are turned off. Close First Principles an restart First Principles. If still not all used units are found, press the button labeled ‘Query system’. If that still doesn’t find all units, contact Hubert Voogd of the TSG.
Align Sensor Units (when using more than one sensor unit).
Define coordinate system.
Connect IRED markers.
Place IRED markers on subject, AFTER BEING SURE THAT THE IREDS ARE NOT GETTING TOO HOT!

(Printable version)

Performing a registration and alignment

Performing a registration and alignment (pdf)

Custom Interface

You can create your own software to communicate with the Optotrak System, both directly and via First Principles. We advice to use First Principles to record your data and communicate with First Principles by using the RTC3D protocol. Find more information and resources in the links below.