1,658
edits
Changes
Jump to navigation
Jump to search
Line 35:
Line 35: − − ===Trigger port === − − [[File:Connector.png|thumb|300x300px|Schematic view of the 25 pins connector]] − − The 25 pins female connector has 8 inputs and 8 outputs, respectively 1-8 are inputs and 9-16 are outputs. Three analog input with an analog to digital convertor of 12 bit, pins 17,18,20 and 21. Two analog outputs with an digital to analog convertor of 12 bits on pins 22 and 23. − − The inputs 1-8 will be pulled down from 5V to GND when the buttons are pressed. The outputs 9-16 will be pulled up from GND to 5V when the output is activated. Line 64:
Line 56: − + − − 2.When you connect the BITSIbox, Windows should initiate the driver installation process (if you haven't used the computer with an BITSIbox board before). − − 3.On Windows Vista/7, the driver should be automatically downloaded and installed. − − 4.On Windows XP, the Add New Hardware wizard will open: − *When asked '''Can Windows connect to Windows Update to search for software?''' select '''No, not this time'''. Click next.+ − *Select '''Install from a list or specified location (Advanced)''' and click next. − *Make sure that '''Search for the best driver in these locations''' is checked; uncheck '''Search removable media'''; check '''Include this location in the search''' and browse to the '''c:/beheer/arduino/drivers '''directory. − *The wizard will search for the driver and then tell you that a "USB Serial Converter" was found. Click finish. − *The new hardware wizard will appear again. Go through the same steps and select the same options and location to search. This time, a "USB Serial Port" will be found.
→Port Settings
== Port Settings ==
== Port Settings ==
===Serial port===
===Serial port===
=== USB-Com port ===
=== USB-Com port ===
1.Connect the BITSIbox to your computer using the USB cable.
1.Connect the Vertical Sync sensor to your computer using the USB cable.
2.When you connect the Vertical Sync sensor, Windows should initiate the driver installation process (if you haven't used the computer with an Vertical Sync sensor before).
'''How to Check the Com Port settings(important!)'''
'''How to Check the Com Port settings(important!)'''