Changes
Jump to navigation
Jump to search
Line 352:
Line 352:
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
no edit summary
== USB-Com port settings ==
== USB-Com port settings ==
1.Connect the BITSIbox to your computer using the USB cable.
2.When you connect the BITSIbox, Windows should initiate the driver installation process (if you haven't used the computer with an BITSIbox board before).
3.On Windows Vista/7, the driver should be automatically downloaded and installed.
4.On Windows XP, the Add New Hardware wizard will open:
*When asked '''Can Windows connect to Windows Update to search for software?''' select '''No, not this time'''. Click next.
*Select '''Install from a list or specified location (Advanced)''' and click next.
*Make sure that '''Search for the best driver in these locations''' is checked; uncheck '''Search removable media'''; check '''Include this location in the search''' and browse to the '''c:/beheer/arduino/drivers '''directory.
*The wizard will search for the driver and then tell you that a "USB Serial Converter" was found. Click finish.
*The new hardware wizard will appear again. Go through the same steps and select the same options and location to search. This time, a "USB Serial Port" will be found.
'''How to Check the Com Port settings(important!)'''
· From the Start menu, open the '''Control Panel'''.
· From the control panel, open the '''System window'''.
· From the system properties window, go to the '''Hardware tab''' and click the '''Device Manager''' button.
· From the Device Manager window, click '''Ports (Com&LPT).''' You should now be able to see which Com Port the USB adapter is assigned to.
· If the Com Port is 10 or higher, you will have to change it to a lower port.
· From the Device Manager window, click on '''USB Serial Port (Com#).''' Click the '''Port Settings tab''' of the USB Serial Port Properties window, and then click the '''Advanced''' button.
· In the Advanced Settings window, use the scroll input to select a '''Com Port''' (select 10 or lower). Change '''Receive (bytes)''' and '''Transmit (bytes)''' to 64. Change the '''Latency Timer''' to 1.
· Click the OK button.
Always connect the usb device to the same port and your settings will be remembered.
== TSG ButtonBox hardware 2013 ==
== TSG ButtonBox hardware 2013 ==